2010 bmw 335i oil capacity




2010 bmw 335i oil capacity

Article Navigation:
  • Photo
  • Oil Change - Max Fill Level Variance
  • Video
  • RELATED PAGES
  • BMW , Engine, Capacity/Filter capacity litres(liters), Oil Change Intervals. i ( – ), N54, , 25 km / 24 months. xi ( – ), N

    Whether you follow BMW's recommended interval or like to change your oil Changing Your BMW Motor Oil and Filter BMW i xDrive Coupe ().

    Interesting fact! In 1937, BMW built the world's fastest motorcycle. It was sped up to a speed of 278 km per hour.

    Here's a small oil change DIY write-up for the BMW E90 (also for E91, E92, E93) chassis. This is a discussion on DIY: Oil Change - BMW E90 (E91, E92, E93) within DIY - Do it yourself, part of the .. 26th March ,

    2010 bmw 335i oil capacity

    2010 bmw 335i oil capacity

    It's just behind the front-center jack point. Find More Posts by Gogud. Download BMW owners manuals. I would rather err on the side of slightly underfilling oil vs.

    2010 bmw 335i oil capacity

    2010 bmw 335i oil capacity

    2010 bmw 335i oil capacity

    2010 bmw 335i oil capacity

    2010 bmw 335i oil capacity

    Motor oil capacity for i

    This is a discussion on DIY: User Name Remember Me? The interval between oil changes is 1 year or 15, miles 25, km. Additional customer requested oil changes are charged. If you feel like saving some money, have an hour or so free on a weekend and want to do an oil change in between the recommended intervals, then here's how you can go about it. I'm not sure what the service intervals are in India, but the procedure wouldn't change. Fully Synthetic Oil [6. Ramps or a lift jack with jack stands.

    Motor Oil is corrosive, poisonous to you and harmful for the environment so please use gloves while handling it. Don't dump used oil down the drain. Most auto-parts chains and repair shops have oil recycling drums that'll let you dump your oil for free. I'm sure such facilities are available in India too - best choices would be a local petrol station, or the corner mechanic. Don't over-tighten your bolts. Some of the bolts will have markings on them - all you have to do is make sure the markings are aligned when you re-tighten.

    2010 bmw 335i oil capacity

    An oil change is best performed when the engine is warm or at operating temperature so drive around for a few minutes before you begin. If you have the Sport Package, the aero rubber-flap in front of the wheels will brush against the ramps and push them forward if the ramps are on a smooth surface or on concrete. Rubber mats placed below the ramp will prevent this slippage. I did my oil change on a tarred road - no slipping.

    I placed a chock behind one of the front wheels and put up a hydraulic lift jack under the other side jacking point, as an additional support - just enough so as not to raise the car.

    2010 bmw 335i oil capacity

    Don't use a stone as chock. Be careful as the engine is hot. Now's a good time to get those nice tight disposable gloves on and loosen the Oil Filter housing - don't remove it just yet. A 29 mm socket is what you need. You can also remove it with your hands and a couple of rags it's hot! If you can make out those blue markings on the Oil Filter housing, you have to match those when you re-tighten. It's just behind the front-center jack point. Remove the hatch so it doesn't interfere when you're undoing the drain bolt.

    It should come off using hand-power but sometimes it might be set just too tight. If this is the first break-in oil change on your car, then the bolt will have a silver metal washer - don't reuse it. If the oil has been changed before, then the bolt will have a copper crush washer - don't reuse it. If the bolt was over torqued by the BMW technician who did your previous oil change, now's the time to put all that gymming to good use.

    Be careful - if the wrench slips you will get hurt. If your calculations were correct, then it'll shoot straight into the Oil Drain Pan. You can see from the picture that I was a little bad at math. Not as bad as aiming for the Moon and landing on Mars but a mess nonetheless. Using the plastic fork pry out the 2 o-rings big black and small green on the housing, and replace them with the new o-rings that came with the new Oil Filter. Note the position of the black o-ring.

    2010 bmw 335i oil capacity

    If you position this incorrectly, the housing won't fit back properly onto the engine. You can use a screw driver or a metal fork too if you wish.

    Also put that new copper crush washer on to the drain bolt now. Just pour small amounts of oil directly onto the filter and watch the material soak it up - nice way to pass time as by now you're bored that all this is taking too long. Also replace the Oil Filter housing with the new Oil Filter and the new o-rings installed.

    How to do an Oil Change on a BMW 335i - DIY for 3-Series E90/ E91/ E92/ E93



    • Подписаться по RSSRSS
    • Поделиться VkontakteVkontakte
    • Поделиться на FacebookFacebook
    • Твитнуть!Twitter

    Leave a Reply

    Return to Top ▲TOP ▲